Pages

Monday 18 June 2012

Recalcitrant Daze - ZM Pillars and Gun Turrets 4

Moulds for Pillars on the way...

When I originally did the pillars to try out Zone Mortalis I had a few people ask me if they could have some to do the same thing. The original master was a very quick build and was destroyed during the moulding process (i.e. I had to break it up to get it out of the mould) which left me with a single mould. There was no way I was going to cast pillars for people as it would of taken weeks to knock enough out.

However I was recently asked again for pillars so I decided to make a new master, one I could use to do multiple moulds. I still won't be casting pillars for people, however I will sell the moulds themselves allowing people to cast as many pillars as they like in plaster.

So here is the new master.


The new design is the same as the first in principal - namely two outer grooves (1.5mm wide) for card walls to be slotted into and a central groove (3.5mm) for a door to be slotted in.

However the new design will use less rubber for the mould and less plaster in the casting. It should also provide a much easier casting experience as the original mould is very awkward and results in lots of air bubbles due to the thin walls which make the grooves for the card to slot into.

It is still plain and simple and I am not going to town making it perfect - it is still intended as a quick, cheap and modular way to try out Zone Mortalis or similar games set inside buildings/tunner sytems/space craft etc.

Like the Mk. I version the pillars are 70mm tall.

Some walls and a door slotted in place.

Gun Turrets.

Recently I asked if people would be interested in buying gun turrets if I built a new one. Well I think I had enough interested via the blog and forums to go ahead and at least do a new master.

So I got out the original master and it's current state is now...


I needed the lego to act as the internal structure of the new model. However it will be slightly smaller (the original was a touch too big) for easier set up. I was not happy with many aspects of the original design so this will be a good opportuniy to do a much better model.

While I would like to get the gun turret done ASAP I have a lot on my plate at the moment (some of which will come out in the near future) so I think it will be a slow build over the next few weeks.

2 comments:

  1. The pillar is looking very nice. Can't wait to see the new turret!

    ReplyDelete
    Replies
    1. Cheers. Hopefully I'll have chance this week to work on the new turret design.

      Delete

Note: only a member of this blog may post a comment.